It’s weekend, and I’ve been at it again. I stitched onto jute scrim using manmade materials, heatgunned it and sandwiched it between more or less translucent fabric, this time lightwight grey lutradur. I’m sorry the pixs are not what they should be, the blue wool is in fact turquoise, and a bit on the greenish side. My scanner hates all shades of cyan, and there wasn’t sufficient daylight for photographs by the time I was done.
I have to say for the first time that I like the sample before the process more than after. Firstly, I had problems with my cheap heat gun, it didn’t get hot enough on the first setting, so I had to use the scond which means 500 °C, and that burned the jute a bit. Also, the grey yarn didn’t melt well. Also, Lutradur doesn’t seem to be the material of joice for such things, not translucent enough and too uneven.
After heatgunning; the grey did not turn that yellow, no idea what my scanner is doing there. I liked that scanner much better before I had a digital camera and saw what this one can do in good light.
after layering; In reality, it looks much more blurred and opaque than this because the scanner will see through the fibers, while in real they will reflect a lot of light blurring everything.
In order to trap such bulky things properly betrween thin fabrics, I put a layer of fusible web on each thin fabric piece, trap the jute in between, then pack it between two sheets of baking paper. Then, I first iron the whole package on a soft cushion, from both sides. That makes the ends stick together well. Then I iron it again on a hard surface to make sure it sticks well to the bulky stuff, again from both sides. Then I let the whole sndwich cool down completely before pulling off the baking paper, because if some fusible web spills through the fabric it will adhere to the baking paper while hot and you may damage your sample when tearing the hot paper away.